Rotary Car Club - View Single Post

Rotary Inspired · 09-09-2009, 08:49 PM

I would run a rotary a bit richer than a piston motor due to the heat it creates. I like to taper from 12.5 to 11.5 A/R from 0 PSI to about 8, obviously around 1,2,3 its pretty close to 13 or so. From 8 to 15 PSI like to taper it closer to 11 A/r. From there I continue to get richer. Hope that helps. Good luck.

09-09-2009, 08:49 PM	#3
Rotary Inspired Rotary Fan in Training Join Date: Feb 2008 Location: SW OKC Posts: 75 Rep Power: 18	I would run a rotary a bit richer than a piston motor due to the heat it creates. I like to taper from 12.5 to 11.5 A/R from 0 PSI to about 8, obviously around 1,2,3 its pretty close to 13 or so. From 8 to 15 PSI like to taper it closer to 11 A/r. From there I continue to get richer. Hope that helps. Good luck. __________________ If you wanna become ASE certified buy the RX7.