[FC3S Murray]

Basically what you do with the WB o2 calibration is: get a mason jar and put the o2 sensor in with the tip of your propane torch. Wrap the SOB in a ton of syran wrap and turn your IGN on to heat up your o2 sensor. Then once the sensor is hot, turn on the propane torch until the gauge reads 9.0 AFR or whatever. What I wanted to tune for was 11.0 AFR and I wanted my datalogit to read 100% correct with my gauge.

So when I turned the propane on my reading skyrocketed to 9.0 AFR. The straw is inserted and you blow a little air into the sealed jar until you reach 11.0(or what ever you want your WOT AFR to be). The you go into you tuning software and adjust your voltage to AFR correlation.

my factory innovative set up was supposed to be 0-5v:9-15.99AFR. I had to cahnge it to 0-5v: 9.2-15.99AFR to get my logs from my datalogit correct with my xd-16 gauge.

Anyhow, Start up happens tonight!!! Stay tuned!