Quote:
Originally Posted by classicauto
What'd you do for the pump sock? I know there's a bit of an issue with makigna piece that isn't going to restrict inlet flow to the pump. Chris ludwig hada beautiful bell mouthed piece he advocated. Just curious what you found or used.
|
Quote:
Originally Posted by RCCAZ 1
Actually, Glen and Tom at AZRR fabbed up the sock for me, but from what I remember before install, it appeared to be nearly identical to what Cosmo shows in his post.
|
That looks identical to the sock that I purchased from Jay Racing. I think it was ~$50
Quote:
Originally Posted by RCCAZ 1
OK everyone,
Installed aluminum WG hardlines over the weekend. Thanks to Glenn and Tom from AZRR for coming over to perform much of the install. Much appreciated guys! They will be selling this kit on their website www.azrotaryrockets.com, so keep an eye out for the kit coming soon!!
Anyhow, after only 900 miles my "state of the art" high temp rubber hose kit had turned to "toast." Lesson one... keep the WG lines as far away from the heat source as possible. I had initially routed my lines NEXT TO the turbo. Bad idea. Lesson two.... now, my WG lines head towards the back of the motor, up the firewall, then around the ABS to my Greddy control unit. Much, much better. Check it out! |
Those WG Hardlines are beautiful. Being an overly anal retentive detail guy myself, your build is incredible. Would love to see it someday
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @
Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-