Rotary Car Club - View Single Post

FirstRotaryExp · 07-03-2009, 10:27 PM

Ive had a 52mm amber/white smoke faced oil pressure gauge installed on my FC for about a year or so now (see the interior section for a post about it) and just recently the gauge will perform its its full sweep upon startup, but instead of dropping back down to the usual psi numbers at hte start it stay's pegged out at max. Would the grounding of the sending unit's 'power' wire cause this or is the gauge itself going south?

07-03-2009, 10:27 PM	#1
FirstRotaryExp Rotary Fan in Training Join Date: Feb 2008 Location: Dandridge, TN Posts: 76 Rep Power: 0	oil pressure gauge question Ive had a 52mm amber/white smoke faced oil pressure gauge installed on my FC for about a year or so now (see the interior section for a post about it) and just recently the gauge will perform its its full sweep upon startup, but instead of dropping back down to the usual psi numbers at hte start it stay's pegged out at max. Would the grounding of the sending unit's 'power' wire cause this or is the gauge itself going south?