Quote:
Originally Posted by FC3S Murray
Ha, I actually measured them bro. Front rotor slots all measured between 2.01-2.04mm. The bad rear rotor had one side with 2.03-2.05 BUT the other side of the rotor measured 2.15-2.18.
No good in my opinion. However, I can not find specs on the wear limits. ONly specs when Apex seal is installed via FSM.
|
Usually the apex seals vary a little in thickness and hence why the FSM has it using the seals as part of the measurements. Check the seals and see what the dimensions of them are. You'd be surprised and might find a few that measure 2.03mm maybe more if they were exceptionally sloppy.