So I got a hold of a Dial Indicator and took some measurements on both my front and intermediate irons.
I was worried about my intermediate and actually have a 40K one on standby waiting to buy.
Here are the pics with measurements.
FRONT IRON
GOOD SIDE OF INTERMEDIATE IRON
Questionalble side of INTERMEDIATE
most of the lips are .001''
This lip was wierd...actual wear line measured less then .001'' BUT then gradually went up until .003'' goings towards the water jackets.
Not to mention it looks like they were sanded down and the overall rotational pattern looks out of place??
I also measured my rotor apex seal grooves with a V Caliper.
Front rotor Apex seal spaces(all 6) above corner seal area measured: 2.02 -2.04 mm
Rear rotor and the questionable one measured on one side: 2.04-2.05mm AND the other side......:
2.15-2.18mm
Bad rear rotor, FUCK! Add that to the list.