[TitaniumTT]

Originally Posted by FC3S Murray

Looks like standard 2mm Mazda

I haven't slept in 40 hours so I'm a little loopy but they look like the old style of aviation seals.

They were associated with chatter marks, HOWEVER, so are other things. I found out today actually that something to really look into would be the correct counterweights/rotor weights used.

Originally Posted by FC3S Murray

I am still a little reluctant if I want to use this intermediate iron. I do not want to fork out that much cash for lapping on the front and intermediate(new rear on is good just needs port). I don't know, my last motor I took apart had even a bigger lip in it and it had 105 compression all around. I would most likely find a ported intermediate that is within spec...themn I won't have to invest the time into waiting on the lapping and cleaing the coolant jackets.

Remember my goal is August. With Family and work that is flying.

Yeah I hear ya on the cash and the timeframe but remember (generally) Rushing takes longer and cheap costs more in the long run.

Originally Posted by FC3S Murray

I planned on doing new side seals. Springs too. QUESTION, what apex seal springs do I go with when I use the RA Super Seals?

Rotary Aviation Race Springs. I believe they are $72/set

Originally Posted by FC3S Murray

Thanks man. I hope this goes well.

BTW good luck with the dyno session tomorrow. I wish for only lots of HP and very few problems. I will shoot you a line if I have any ques's.

Take your time and I'm sure it will... as for the dyno, we didn't even get passed the pre-dyno compression test Details in my thread so as not to jack yours. Shoot me a line if you have some questions and you also have a PM.