Holy shit I have been busy. At this rate I won't get the damn engine in 'til mid August. I need to hustle.
Anyway, I was able to get some free time last night and "sand" off that fucking JB Weld
Here is the abomination before I ripped into it
AND afterwords
I ended up rounding the edge of the rear rotor housing a little bit. Regardless I can catch my finger nail on the rear iron and rear rotor housing mating surface. It should just come off easy now.
Tomorrow I will safety wire the rear and front rotor housings tight to the exhaust studs to secure it from lifting and shifting water seals upon disassembly.
MAN that shit went everywhere when I put the dremel to it. MESSY but those sand paper flapper wheels are the bomb!
I will update soon.