Rotary Car Club - View Single Post

bbade · 06-15-2009, 10:53 AM

I spoke with Ray at Malloy and was quoted about $300 for the glovebox assembly. The only solution I have come up with would be to recreate a portion of the inner shell out of aluminum. This new piece would have the latch assembly attached to it and in turn would be attached to the outer and inner shells. I highly doubt that it would be possible to attach the inner and outer shells like stock if you broke the original "welds."

I am hoping to find a used glovebox as it will be a much cleaner install. On that note, if anyone has a 1993 glovebox for sale I will gladly take it off your hands.

06-15-2009, 10:53 AM	#7
bbade Rotary Fanatic Join Date: Mar 2008 Location: Macungie, PA Posts: 163 Rep Power: 18	I spoke with Ray at Malloy and was quoted about $300 for the glovebox assembly. The only solution I have come up with would be to recreate a portion of the inner shell out of aluminum. This new piece would have the latch assembly attached to it and in turn would be attached to the outer and inner shells. I highly doubt that it would be possible to attach the inner and outer shells like stock if you broke the original "welds." I am hoping to find a used glovebox as it will be a much cleaner install. On that note, if anyone has a 1993 glovebox for sale I will gladly take it off your hands. __________________ Proud owner of a base 1993 Montego Blue FD. PFC, RB single tip, Koyo Radiator, KDR rebuilt motor, polished OEM front strut bar, FEED replica sideskirts, OEM 99 spec rear spoiler, SuperPro Bushings Many thanks to Dave at KDR for sparking my rotor addiction.