So here we are with the center plate (and the new RX8 eshaft) but no o-rings. I like to do them one surface at a time. What if right? Don't need those bastards swelling so.........
Put them on along with the dowels. The dowels are there for alignment. Why put a housing on and have to move it? I've moved o-rings out of place before trying to align a housing. now I just put the dowels in first.
Apply liberal amounts of oil
Insert rotor...... With the last engine, on the last corner seal before the thing was done it was being stubborn. It finnaly moved and jumped out of it's hole and hopped into a collant passage  It took me about 15 minutes to fish it out with a magnet wrapped in electrical tape becuase it kept pulling towards the irons while I was trying to get it down to the front plate. THen it wouldn't pass through the housing so I had to shave the tape. It was an infuriating nightmare. I was seeing red. Anyway, now when I take the corner seals out I use a magnet to pull them out so something like that can't happen again.
And then the plate and the tension bolts. Pretty normal or so I think. Tomorrow, or later today actually, I'll set the end float and start putting the periperals on. Still planning on being at KDR on the 17th for a dyno and then hitting Limerock the next day.
I bought a set of Work VSXX's of a friend who is parting his car. They are 17x8 & 17x9 wrapped in 235/40 & 255/40 RA1's. I got them for a deal that I couldn't pass up. I can't wait to so some damage to them. They should be here today... WOOT!
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
|