Rotary Car Club - View Single Post - HELP: 1st gear + clutch + brake = stalling out

GoodfellaFD3S · 04-27-2009, 05:53 PM

-360 at 1000 rpms? That's about 14 inches.

Based on that your motor is fine. I don't think those compression #s are accurate.

Why not bring the car over to IRP and have Ihor look over it for you? Would save lots of wasted time, as there are many variables here that could cause your problem.

Also, when I was troubleshooting your issue at DGRR the motor was ok, but seemed to have low compression. It didn't have a chipped seal or anything of that nature.

04-27-2009, 05:53 PM	#17
GoodfellaFD3S Rotary Fan in Training Join Date: Feb 2008 Posts: 40 Rep Power: 0	-360 at 1000 rpms? That's about 14 inches. Based on that your motor is fine. I don't think those compression #s are accurate. Why not bring the car over to IRP and have Ihor look over it for you? Would save lots of wasted time, as there are many variables here that could cause your problem. Also, when I was troubleshooting your issue at DGRR the motor was ok, but seemed to have low compression. It didn't have a chipped seal or anything of that nature. Last edited by GoodfellaFD3S; 04-27-2009 at 05:56 PM.