Finally, some minor progress.
I got the subframe out, steering rack out and finished coating both upper inner fenders.
Plans for next week are to undercoat lower inner fenders and finish polishing the control arms. My new wheel bearings should be in by that time as well so I will install those and clean/repaint the hubs while they're out.
Also, I plan to modify the front subframe after christmas. I noticed there were areas that lacked reinforcement that would be easily added in without altering any mounting points, etc. I'll get pics up of the modifications.
Here are some pics:
Driver's side upper inner fender:
Passenger side (lil blurry):
Subframe out:
All the parts ready to be stripped, cleaned and re-used if needed. Only things going back on are the hubs and parts of the steering rack:
Oh, and a little early XMas gift that I couldn't pass up, my 13B-RE engine mount adapters courtesy of RPM Motorsports:
probably wont have much to update until after Xmas.... but it'll be a good update next time...