|
Scratch using the last two nipples on the UIM-check.
For the EBC, I have a solenoid valve and a sensor, 2 lines go to the valve (NC and COM) and one goes from near the MAP sensor nipple to the sensor. Is that what you're talking about?
The way I had it set up is with the line coming from the side of the WG to the T, another line going to the NC port on the solenoid, and the last line going to the IC piping. The way I have it NOW though, I swapped the line going from the WG side to that T, now it is going to the UIM near the TB and just a single line is going straight from the NC port to the IC piping. Know what I mean?
|