[RXVERT]

I did'nt do this part, but I watched so, I'll try to explain, The wing was cut into 3 pieces which exposed a hollow v shape pattern of the exposed end pieces. You'll need something solid to cap off the end pieces. Thats the 2 exposed end pieces on the long part on the center trunk, and then the right and left fender pieces that are exposed that face the end pieces on the center trunk. (4 end caps) Then (templates) or patterns were made from the exposed wing end pieces. 14 gauge metal was used next, you'll need to rough up the metal, and make absolutly sure its rust free. Then Metal templates were welded to the trunk lid and the fenders, you then apply 3M urethane adhesive to the metal pieces and also to the spoiler to adhere and shape the spoiler onto the metal, which acts kinda like a body filler. Shape, harden, ( note: dries extremely fast) sand and sand and sand. These picts aren't picts of how it was done but you might draw a rough picture in your mind.