http://www.rx7club.com/showthread.php?t=525920&page=32
Fully Built motor with some custom coolant mods done to it. JHB Cermet B Rear rotor housing, lapped side plates, competition everything as far as bearings goes, tear dropped eccentric shaft, 2mm Iannetti one piece apex seals, and viton oil and water seals.
GZ LIM, 4 1000cc Secondaries control by an FJO injector controller, 550cc stock primaries, Apexi PFC, Datalogit, custom V-mount cooling package, A-Spec tuning 500R with custom 0.84 A/R Hotside, Synapse WG, Synapse BOVs, XS engineering ignition amplifier, etc.
Power right now is 400 whp at 7400 rpms and 300 ft-lbs at 6400 rpms, at 15 psi of boost and conservative timing.
Video of first dyno session.
http://videos.streetfire.net/video/F...yno_171589.htm
