Quote:
Originally Posted by sk8world
from side of port to were the oring groove (water seal) goes. I was worried as mine were smack on 10mm and I read several saying do not go below this so corner seal has enough to support it?? School me some more!
Parts!!!
My shipping is:
Mike Jtineant
Skateworld, Inc.
3185 Leeman Ferry Road
Huntsville, Alabama 35801
256-880-7860
sk8world@hiwaay.net |
Well the fact is I am not actually sure what the limit is in mm, I don't use templates for my porting it is a combination of the time spent learning from Paul Yaw and simply mocking an engine up, rotating and studying the limits and effects of our ports. But I assure you the corner seals in supported and the rubber plug is as well.