Quote:
Originally Posted by TitaniumTT
Hoe Shit! Fuck that! Did you add extra grounds and use lots of dielectric grease?
|
No extra grounds, but I had the greased them up good. I'm going to depin all the clips and scrub the hell out of all the tabs then crimp the female side so the pin will barely fit in. Also going to check the crimps on all the pins. Will probably just flow some solder into the crimped clips for good measure.
If this doesn't work, then I'm just going to drop the damn electric steering for a different rack. Probably use a Mark III MR2 electric motor.