View Single Post
Old 06-18-2015, 09:41 PM   #1
Turblown
Rotary Fan in Training
 
Join Date: Apr 2013
Posts: 59
Rep Power: 13
Turblown is on a distinguished road
Shop FC Street Car

Street Ported S4 Block with FD stat gears/bearings
Walbro 460lph E85 Pump, 10 micron fuel filter
stock primaries/ID2000 secondaries
Parallel Fuel system with Aeromotive Race Reg
Flex fuel sensor, E65 Corn blend
Adaptronic E440D wire in model
Our T4 IWG EFR 9180 FC3S system with 4" downpipe/midpipe and 3" n1 catback
Act street/strip clutch
4" ambient air intake
Efan/Koyo
IGN-1A coils, NGK R7420-10s, MSD wires
Complete Inconel heat shield enclosures( not pictured)
Tein Coilovers, every mount replaced etc, etc

Out of fuel pump, adding a AI surge tank with a second staged walbro 400, 4 ID1700s and 25-30psi. Probably turn it down though, and switch to a 8374. This turbo is moving to our roadrace FD3S chassis( currently runs an 8374 @ 31psi).
Attached Images
File Type: jpg Turblown EFR 9180 FC3S Rx7.jpg (127.7 KB, 52 views)
File Type: jpg Turblown T4 IWG 9180 FC3S.jpg (92.3 KB, 35 views)
File Type: jpg 9180 T4 IWG Rx7 Dyno.jpg (170.5 KB, 40 views)
__________________
Turblown Engineering - Rotary Turbo Kits, Rotary Adaptronic ECUs and Rotary Performance Parts.

TurboSource - Performance TurboChargers, Inconel Heat-Shields, and Adaptronic Distribution
Turblown is offline   Reply With Quote