I've been through this shit on other forums. my advice is build a bridge and get over it, better yet, build something for rotaries and show it
This place I find better than any of the others I have been in, I dont know this bloke nor am I sticking up for him any other way than its good to see people post stuff on here that is rotary related and is good.
FUCK KNOWS there is enough Howard Colemans in this world and shit forums like GAYCLUB7.com
Fucken GET ON IT :-Oc==3
Get out there and build some thing, test some cars, contribute and do it, no point having a go at someone for having the guts to get out there and make something, a man who has never made a mistake has never done anything!
Pants off to anyone who builds things and contributes I say. I talked shit for years against c-u-n-t-s apex seals, when I should have been out there long ago building them correctly!.
Same for anyone if you can do better go fucken make it! any rotary product or service.
Cheebs you can weld n shit, go make a manifold mate! till then leave this poor c-u-n-t alone, unless of course he talked shit against you or ripped you off or something else I am not aware of? then do that in a vendor thread?
All I can tell you is its hard enough and there is not enough people like us who actually make things, getting shat on by internet c-u-n-t-s and or other groupies while may be a tactic for some to get rid of competition or petty retribution, it is nothing less than a low act and pretty poor given someone is getting out there and doing things. Be they good or bad will pan out with honest review on any one said product or service in good time.
Only thing I would say in regards to this manifold, dump pipe, turbo system, put up some more info when you can, performance figures etc.
Peter