Quote:
Originally Posted by GySgtFrank
One of the folks in St. Louis is working on some. He posted this on the STL RX Club facebook page. It sounds like they're still trying to work out the bugs with manufacturing and testing. It looks like it uses a common press-in ball joint.
https://scontent-a-dfw.xx.fbcdn.net/...61&oe=552944FC |
Oh my oh my..... sexy....
However... looking at Gunny here... how would those affect roll center... I'm failing to see that...
Quote:
Originally Posted by project86
they do indeed.. for $77 a side. Ill probably be ordering them soon. I need to clean up the hubs first too. I wanna get all the front end stuff taken care of while i have the front of the car up on stands.
|
Bah... are they replaceable after the fact?
Wait.... wut? I'm not seeing those... I'm just seeing the replacement ball joints...
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @
Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-