Rotary Car Club - View Single Post - IV-Rotor Build: 12 plugs/ 9 bearings/ 8 ports = 1 monster

GtoRx7 · 06-09-2013, 08:54 PM

Bet you guys didnt think this was possible based off the beginning huh? I'm not a professional painter, but many guys who have stopped by think I am

This one goes to Matt, he came up with using a motor plate idea. I liked it, and started to fabricate using the dummy engine. This made the whole package so easy to install and remove

Now onto the 4-rotor! After all that is what everyone wants to see. 1st off the aluminum side housings. So light, so nice.

The ultra-light rotors

P-port all epoxy sealed

06-09-2013, 08:54 PM	#8
GtoRx7 Rotary Fanatic Join Date: Jul 2008 Posts: 151 Rep Power: 17	Bet you guys didnt think this was possible based off the beginning huh? I'm not a professional painter, but many guys who have stopped by think I am This one goes to Matt, he came up with using a motor plate idea. I liked it, and started to fabricate using the dummy engine. This made the whole package so easy to install and remove Now onto the 4-rotor! After all that is what everyone wants to see. 1st off the aluminum side housings. So light, so nice. The ultra-light rotors P-port all epoxy sealed __________________ DEFINED AUTOWORKS Where concept meets results Black 1994 FD 4-rotor 610rwhp all motor Red 1970 Mazda R-100 with 10a Black 1974 Mazda Rx4 Black 1984 Gsl-SE 13b-re streetport 230rwhp