Day 2 of the build went pretty good. I made a call to the local Mazda dealer and ordered all the gaskets I need. They should be here tomorrow with any luck. I then started making my block off plates for the ACV valve and the cat air pipe. They were pretty simple. Just trace, cut, and sand. Pretty straight forward. Here's a few pics of that. There's also a pic of some of my left over parts.
DSC00195.jpgDSC00196.jpgDSC00197.jpgDSC00199.jpgDSC00198.jpg
__________________
1976 Rx-4 hardtop. Half bridge 3B 13B, S5 NA rotors, Renesis e-shaft, stat gears, and bearings, balanced rotating assembly, RE dual weber 36 DCD's 203rwhp 137ft-lbs torque DGRR 2011 3rd place
1974 Rx-4 all original 27,000 miles
1988 Rx-7 TII 320rwhp. DGRR 2012 3rd place
|