Rotary Car Club - View Single Post

AHarada · 05-11-2008, 03:13 PM

My motor is put back together and the rear stationary gear is ready to be put on and torqued. I'm having a problem getting the pin on the rear iron to line up with the slot in the gear. I can rotate the E-shaft and the teeth will fall into the rotor, but the pin will still not line up, it's off by probably less than 1/16th of an inch. I rotate the E-shaft completely around several times and it still will not line up. Has anyone experienced this? Oh btw, I'm using a RX8 rear stationary gear.

05-11-2008, 03:13 PM	#1
AHarada Rotary Fanatic Join Date: Mar 2008 Posts: 162 Rep Power: 18	Installing rear stationary gear My motor is put back together and the rear stationary gear is ready to be put on and torqued. I'm having a problem getting the pin on the rear iron to line up with the slot in the gear. I can rotate the E-shaft and the teeth will fall into the rotor, but the pin will still not line up, it's off by probably less than 1/16th of an inch. I rotate the E-shaft completely around several times and it still will not line up. Has anyone experienced this? Oh btw, I'm using a RX8 rear stationary gear.