[Mitchocalypse]

Originally Posted by Prodigy

you might want to try filling the shit out of those connections with die-electric grease before you try rtv... if you got grease in there it should displace any water trying to get in




no caps lock next time please... it was hurting my head

Mitch, you cut off the one seal on the rack portion of the steering system? did you weld the quill shaft as well..?


either way.... its looking mighty fine... keep up the work habit..

edit: can you put up the link to the 7 club with the fuse box moving/wire tuck....?

thanks


J.

Yes, seal was cut. And the quill shaft wasn't welded. I was trying to follow the DIY on the miata site best I could do the only welding done was on the fittings where the lines connected to the rack to give them a top like an actual screw and not just a hole.

However, I'm taking the rack out again tomorrow to clean it. I just ha to put it back in to move the car from location a to location b.

And about the wire tuck.. The DIY (prew's) wasnt that great.. I changed a lot of stuff and I think it is 1000 times easier my way and is 99% as clean in the end. Loses the 1% because I'm still using the plastic wire loom holders/ brackets that run under the bumper support and you can just barely see them. Mind you, that should go away when the bumper is actually ON. So when you come to help me put the engine in ( ) I'll give you a tour of the wiring

Originally Posted by RICE RACING

The ONLY point of failure is Karak or Rotaryevolutions business model LOL

Trust him and any other vendor on gayclub.com at your own risk

ALL of those kuuuuunttts have never proven anything except that they themselves have no running cars let alone ones that are fast Just Saying

You should take advice from people who are not vendors on gayforums, but people who are doers, people who have cars, people who actually are engineers, no cock wash wannabe's who pay for the right to post shit to bottom feeders on a shit forum like Karak rotaryevloution does.

I get tired of trying to help people when there are just soooo mannnnny kuuuuuuunts like him on the internet.

I often wondered about Karack.. In his posts he seems to know his stuff pretty good but then as mentionned, why did his business crater? I don't like seeing a small business go down like that but at the same time, that doesn't happen for no reason. And it's not like other rotary shops are in some kind of hardship right now.

I didn't realize the Biggest flaw of the other forum until you pointed it out.. Paying vendors are always correct. Even if they are wrong. And if you try to correct them, you are wrong, your post is deleted, and you are given a warning/ban.

And I was really strongly considering having Karack do my engine because a lot of the stuff he posts is seemingly legit. But maybe that's because any opposition and discussion of the subject matter is deleted so a vendor appears correct and knowledgable.

I'm tired and ranting.
/day