Quote:
Originally Posted by JustJeff
Here is what I found. The two large vacuum hoses on the Purge Control Valve have turned soft and jelly-like and literally won't stay on the PCV. I have removed as much of the vacuum routing as possible but left the rats nest in place. I don't think I routed anything incorrectly...but user error is always possible. Going on the assumption that everything is routed correctly; my question is why those vacuum lines have turned to jelly? Oil blowing through the hoses?
Possibly related and possibly just normal behavior. When I first turned the rebuilt engine over and letting it idle, warm up, etc. I was checking fluids and listening for bad noises. I noticed my oil filter got amazingly hot. Too hot to touch and I was worried enough that I shut the engine off. I couldn't find anything out of place so I went ahead and proceeded with breaking in the engine and I haven't noticed the oil filter or oil temps being unusually high. I've got an aftermarket oil temp gauge and the numbers stay in the normal range.
|
WRT the PCV hoses, the two hoses on the bottom of the PCV often turn to goo. That would be the large diameter one that goes to the oil filler nipple on the housing and smaller one routes back to the intake mani via the rats nest IIRC. Both see crankcase/oil vapors, so over time a cheaper grade rubber hose (regular vacuum hose) or a standard unlinered silicone hose will breakdown. Look for hose rated as an "emissions" hose to replace those; it's nitrile rubber IIRC, which is designed to be compatible with oil vapors.
The oil filter being too hot to handle is probably normal - depends on your threshold of pain. I've got an oil temp gauge on my FC, and if I touch the filter while the oil temp gauge is reading a normal 195F, I find the filter too hot to handle.