[StephenSheppard]

Here's the granny's kit.









I opted for the clutch slave cylinder mounting thing for a 4 speed transmission from an older Chevy (60-70s?). The older transmissions had mechanical linkage (Clutch cable I guess). Granny's makes a kit to bolt up a factory Mazda slave cylinder and gives you the clutch release fork and all that as well. The matching 3/4" bore Wilwood master cylinder to go with it was ordered as well. the only thing I'm lacking is the clutch hose. I'll just put AN fittings in the master and slave and get a stainless hose made. Simple stuff.

I bought the bellhousing from a old guy in DFW that builds 60's era drag rails. Made a friend as well. I'm sure his knowledge will come in handy should I need advice. He's been building SBC and BBCs his whole life. Super nice guy as well. It showed up painted orange. It's aluminium so i will media blast it and leave it natural. Looks like this: a.k.a. pumpkin head.





The granny's kit comes with new hardware and stuff, but I absolutely despise black oxide hardware, and I dislike zinc coated steel bolts. So I spent like $90 on a bunch of stainless hardware to replace it all, I got a few extra pieces of hardware as well for other stuff. Got to start out baller then crumble to peasant status as time goes on. It's not all in this one photo but you get the idea. Bolt Depot plug.



Some pics of the Granny's driveshaft. Grant does good work I like it more than I thought I would. I need to aquire the front yoke still from a Camaro or something similar. Not a big deal no hurry, I have yet to buy the gearbox anyways.