View Single Post
Old 09-11-2012, 11:51 AM   #65
infernosg
IT'S ALIVE!
 
infernosg's Avatar
 
Join Date: Dec 2009
Location: Richmond, VA
Posts: 811
Rep Power: 16
infernosg is on a distinguished road
Quote:
Originally Posted by Pete_89T2 View Post
A T2 hood would make a great cold ram air intake to those filters. Looks like they are about the same size and similar placement as the stock T2 intercooler. Just fabricate up a box to enclose the filters that is open on the top side, with your choice of sheet metal or fiberglass, and stick a mating flange surface along the open top side that matches up to the rubber seal under the scoop area of the T2 hood. Tip - borrow a T2 IC to use as a template. To locate the box and keep it in the right placement with the hood closed, you can fabricate AL bracket(s) to rigidly mount the box to one or more of the unused threaded holes on the keg that were once used for the vacuum plumbing.
I really wish I had a TII hood to mess with. Otherwise, what you laid out is what I was thinking. I'd have to pass the throttle cable through the airbox though. I also want to make a cut out in the hood and add some ducting to vent the radiator but I'm not sure how that would work with the TII hood scoop (i.e. would I just suck the hot air back into the intake)? Once I get the car running it's definitely something I'm looking into.

The main harness is completed. It still looks pretty ugly but as long as it keeps the wires dry/cool it'll do for now. All that's left are alternator power wires, the starter power cable, the spark plug wires, and trimming the transmission harness once the dummy engine's out.



This area was a PITA:



I put the alternator and spark plugs in to get an idea of how to route the spark plug wires:



I'm thinking 90 degree boots at the coils then the wires run next to the fuse box, over the alternator, and down to the plugs with straight boots. This should keep them from the main harness and any wires it comes near will be crossed at 90 degree angles.
infernosg is offline