Just about done mounting the IGN-1A coils in the car. Here's some in-process shots while the bracket is being painted. Test fitting the bracket in the car:
A little closer:
It's pretty simple really; just two pieces of 1/8" flat stock formed to shaped and drilled a couple times. My welds still suck but it'll hold.
Pretty simple again. Six 1-1/2", four 1" spacers, and some 10-1/2" sections of all-thread and the coils are mounted. I plan to run the spark plug wires together up by the main fuse box and then down to the spark plugs. Once I have everything finished and mounted I'm going to take some measurements and give a call to Magnecor for some custom length 10.5 mm wire.