Rotary Car Club - View Single Post - Twin Charged FD

RX SE7EN · 10-29-2011, 08:21 PM

Started on the new manifold, going to mate it to a Q45 throttle body.

I started off wanting to keep the basic layout of the stock UIM, clean up the inside and replace the top with a flat plate of aluminum. Since it's supercharged, I don't really need all of the runners and cross pulsewidth/resonance stuff that is built into the UIM.

It started off looking pretty neat... And yes, I like the grind, hammer, and pry method of demolishing cast aluminum

10-29-2011, 08:21 PM	#73
RX SE7EN Rotary Fanatic Join Date: Feb 2010 Posts: 183 Rep Power: 16	Started on the new manifold, going to mate it to a Q45 throttle body. I started off wanting to keep the basic layout of the stock UIM, clean up the inside and replace the top with a flat plate of aluminum. Since it's supercharged, I don't really need all of the runners and cross pulsewidth/resonance stuff that is built into the UIM. It started off looking pretty neat... And yes, I like the grind, hammer, and pry method of demolishing cast aluminum