And this is where it started getting a little out of control......
I started with a .125" piece of 5052 (I think) and cut it into a gusset.
Then I looked over at the dimple die set that I had bought 3 months prior for a project that didn't materialize and decided it was time to start playing around with it.
Start by cutting out the appropriate size hole
Then press, weld, and repeat and repeat and repeat and repeat and repeat and repeat and repeat and repeat and repeat and repeat and repeat and repeat and repeat and repeat and take a picture
It might be a little overkill, but I don't care, it had to look symetrical.
I also had a bunch of 3031 perforated AL left over from my hood project. I knew I wanted to carry a bunch of fuel with me to the track in 5 gal Jerry Jugs, a solid floor would collect a bunch of shit, so this stuff was perfect. Welding .050 perforated AL to .125" 5052 is a BIOTCH!!!!!!! but the look is alot cleaner than using rivets.
I didn't think it would have been strong enough, and honestly it might not have been, but I decided to hold off on reenforcing that until another time. As it turned out, when I started positioning the axle, I didn't need to. The axle tube fits flush underneath the flooring and center in the tanks. Got lucky there.
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
Last edited by TitaniumTT; 09-28-2011 at 11:41 PM.
|