|
Had a shitty setback this arvo, stayed back at work because I was going to bend some of the pipe up. 2 problems I have encountered, the minimum diameter I can bend my tube too is around 3" and my flaring tool requires me to have around a 45mm straight section to allow me to fit the feral on and flare it. So now I have to either
Make some of my pipes out of braided line with 90deg fittings
Buy a new flaring tool that requires less straight section to clamp
Find a way of bending the tube around a tighter radius
However I don't think its possible to have much smaller of a radius to bend the tube properly, going to do some research tonight.
|