|
sure, um the gsl-se and the 86-88 NA cars make doing this very easy, so its a good place to start. my car happens to be 100% stock, mileage is 76K now, 74k at the time.
so the 6 port cars use exhaust backpressure to move the 5th and 6th ports, so all i did was tee a boost gauge in the 6 port hose, and then go for a drive.
the results were interesting, the gauge and the butt dyno agreed 100%, or more accurately the boost gauge and the tq curve agreed.
the stock exhaust did ok, up to about 4500, then backpresssure starts to climb. so its under 1psi, until 4500 then it comes up pretty quick and peaked around 4.5psi.
i pulled the cats off, and behold the center cat was all melty, so i hollowed it out, and was rewarded with 3.5psi of backpressure. seat of the pants improvement was bigger than the SAFC.
the next step would be to put the gauge actually in the exhaust manifold, i'm not sure but i suspect i'm measuring the rear half of the exhaust. as the pickup is in the main cat.
the concept works though, and its easy to do. higher exhaust pressure = lower power.
|