View Single Post
Old 04-07-2008, 07:03 AM   #3
Barry Bordes
Rotary Fanatic
 
Barry Bordes's Avatar
 
Join Date: Feb 2008
Location: Slidell, LA
Posts: 191
Rep Power: 18
Barry Bordes is on a distinguished road
I cut each side seal to the specific rotor location. Unfortunately each rotor corner is slightly different. I then rock the apex seal to check for binding of the side seal. If any is found I increase the cut on that side.

One advantage I noticed was that on final assembly the apex seal always slides in fully. It is perfectly aligned. No fishing with a pick to straighten the lower corner seal position!

Barry
Barry Bordes is offline