Rotary Car Club - View Single Post

Revelc · 05-23-2011, 06:26 PM

I can measure the protrusion spec with my calipers. It's the bore diameter that I just wanted to double check. Neither source lists the specs of the bore gauge they are using.

It's this procedure:
http://www.turborx7.com/rereplacement.htm
Section 6.A

Or in the FSM, page C-55, procedure 5.

05-23-2011, 06:26 PM	#3
Revelc 20b Tinkerer Join Date: Jun 2010 Posts: 15 Rep Power: 0	I can measure the protrusion spec with my calipers. It's the bore diameter that I just wanted to double check. Neither source lists the specs of the bore gauge they are using. It's this procedure: http://www.turborx7.com/rereplacement.htm Section 6.A Or in the FSM, page C-55, procedure 5.