View Single Post
Old 02-20-2011, 04:09 AM   #1
RICE RACING
Don Mega
 
RICE RACING's Avatar
 
Join Date: Dec 2008
Location: Utopia
Posts: 1,688
Rep Power: 18
RICE RACING will become famous soon enough
Thumbs up Compression measure on testing bed 13B-REW at high power.

Here is an update of the durability (measured by compression) of a stock 13B-REW (from brand new) when run at sustained high power. Taken form my postings on Aquamist Water Injection site.

Quote:
Originally Posted by RICE RACING View Post
Thanks Richard :smile:

I really have my heart set on it sitting on a steady 1.2 bar or 17.5psi inlet manifold pressure and when the weather cools down here maybe try 1.4bar ~20psi, I will update the VBOX3i testing figures once I get my hands on the methanol and mix up a batch. All levels I have run before in my old cars and in customers ones........

Tested the compression of the engine after 1800km and its good for a rotary at around ~122psi @ 250rpm (front and rear rotor same) cranking speed. Will keep an eye over this long term.



I changed the porting specification to give the engine much more mid range power and not concentrate on top end power so much, it is quite fast on road despite relative low levels of peak power. I am projecting it will have a honest 480bhp to 500bhp (at the higher 1.4 boost setting) but will see what happens when I get around to testing this.
So a full year on and covered another 6000km (to date: all up 8200km) of testing/racing/top speed trials.
Summary: Every drive has been quite high load 90-140 testing probably around 400 or so of these tests, many 100-200kmh & 60-130mph runs (3rd to top of 4th gear) and a few top speed runs (on special test track ). Last 3000km at ~500bhp level @ 1.53kg/cm Boost level.

I did one intermediate compression test between the 1800km and this one today, but only wrote those figures down rather than taking a photo/proof. They were close to the ones today.

Rear Rotor


Front Rotor


This test was fully dry (engine run till out of fuel) and EGI disconnected, First one cant remember but I think was not as "empty" of excess fluid, this makes a high difference to rotary engine compression readings FYI.

Anyway she is not too bad, I did not think it would hold up this good especially given its a mobile test bed each and every single time it gets driven.

I have it at its new boost level of 1.7bar (around 1.75kg/cm) and it is a rocket see if she can make another year of punishment
__________________
www.riceracing.com.au
Worlds best
Apex Seals
Coil on Plug
Water Injection
ECU Calibration
RICE RACING is offline   Reply With Quote