Rotary Car Club - View Single Post

speedjunkie · 01-26-2011, 10:10 AM

I was thinking the same thing with 3mm seals LOL. Although I'd heard before that they don't seal as well as 2mm seals. Like you said though, everything is heresay. I take everything I hear with a grain of salt but it also makes it very difficult to make a decision lol. All I can go off of is my own experience and who I choose to believe about this or that, ya know? But that's life I guess.

I figure I'll break the old engine open this weekend and see what's usable, if anything. I just called Ray and a new engine is $3800 with core. Yikes. I can't afford that right now. That would take me at least until April to buy that and then I still wouldn't be ready, and that cannot happen LOL.

I've never worked with the M1009 so I couldn't tell you. Sounds like a crap shoot though, like everything else haha.

I think I might stick with the REW e-shaft just in case.

How much does cryo-treating cost generally?

01-26-2011, 10:10 AM	#13
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	I was thinking the same thing with 3mm seals LOL. Although I'd heard before that they don't seal as well as 2mm seals. Like you said though, everything is heresay. I take everything I hear with a grain of salt but it also makes it very difficult to make a decision lol. All I can go off of is my own experience and who I choose to believe about this or that, ya know? But that's life I guess. I figure I'll break the old engine open this weekend and see what's usable, if anything. I just called Ray and a new engine is $3800 with core. Yikes. I can't afford that right now. That would take me at least until April to buy that and then I still wouldn't be ready, and that cannot happen LOL. I've never worked with the M1009 so I couldn't tell you. Sounds like a crap shoot though, like everything else haha. I think I might stick with the REW e-shaft just in case. How much does cryo-treating cost generally? Last edited by speedjunkie; 01-26-2011 at 10:12 AM.