Rotary Car Club - View Single Post

speedjunkie · 12-20-2010, 01:39 AM

I'm going to have some spacers made for where the LIM bolts to the engine because my fuel rails press against each other (I have an equal length LIM and CJ Motorsports fuel kit). For more info about this, see this thread...

http://rotarycarclub.com/rotary_foru...130#post135130

Anyway, I was planning on having it made out of aluminum but I wanted to check and see what you guys thought first. Can anyone think of a better material to use than aluminum? I'm going to use an OEM gasket on each side of the spacer too btw.

12-20-2010, 01:39 AM	#1
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	Lower LIM gasket/spacers I'm going to have some spacers made for where the LIM bolts to the engine because my fuel rails press against each other (I have an equal length LIM and CJ Motorsports fuel kit). For more info about this, see this thread... http://rotarycarclub.com/rotary_foru...130#post135130 Anyway, I was planning on having it made out of aluminum but I wanted to check and see what you guys thought first. Can anyone think of a better material to use than aluminum? I'm going to use an OEM gasket on each side of the spacer too btw.