Quote:
Originally Posted by Herblenny
Are you making these? I like!!!!
|
Yes i need to make one for my brake set up. Its for a 14 inch brake rotor.
I don't think it will make sense to make it as a kit, just because so many different rotor diameters will be to much work/money to make the necessary offset bracket for every set up were demand will be so low. If some one wants a kit i can make it at the same time i make mine.
Quote:
Originally Posted by speedjunkie
^Do you have a write-up on how you did that? I was looking to swap mine but I knew I had to make some new lines and I don't really need it yet on stock brakes so I just waited. But if I could work it like you did I might replace it sooner.
|
I will post some pics for you in a couple of days. I have machined a couple of 969 master to make it more fd rx7 friendly install. I have one on my bench for custo, will post pics when done machining it.