Rotary Car Club - View Single Post - help, looking to build a bad a$$ 6-port?

NoDOHC · 11-30-2010, 11:41 PM

REW intake does not support 6PI for one thing. For another, I don't think the ports would line up well (never tried it with a 6-port, but I doubt that the ports are in the same location between an REW and a 6-port).

The stock LIM is fixable, it is the UIM that is hopeless. A custom UIM is not impossible, You could use parts from the stock UIM. It takes skill to TIG cast aluminum together and make it look decent, but it can be done. I was going to do that some day, but I seem to find enough to do.

11-30-2010, 11:41 PM	#10
NoDOHC The quest for more torque Join Date: Sep 2008 Location: Sheboygan, Wisconsin Posts: 855 Rep Power: 18	REW intake does not support 6PI for one thing. For another, I don't think the ports would line up well (never tried it with a 6-port, but I doubt that the ports are in the same location between an REW and a 6-port). The stock LIM is fixable, it is the UIM that is hopeless. A custom UIM is not impossible, You could use parts from the stock UIM. It takes skill to TIG cast aluminum together and make it look decent, but it can be done. I was going to do that some day, but I seem to find enough to do. __________________ 1986 GXL ('87 4-port NA - Haltech E8, LS2 Coils. Defined Autoworks Headers, Dual 2.5" Exhaust (Dual Superflow, dBX mufflers) 1991 Coupe (KYB AGX Shocks, Eibach lowering springs, RB exhaust, Stock and Automatic)