View Single Post
Old 10-12-2010, 06:09 PM   #7
rx4ur7
Rotary since 1972
 
rx4ur7's Avatar
 
Join Date: Nov 2008
Location: Tucson
Posts: 231
Rep Power: 17
rx4ur7 is on a distinguished road
System checker is Mazda's OBD reader of the time. I do not know if any of the new readers have the adaptor to fit that early a system.
Really do not know if you can pull the codes without it. Got mine from Mazda back then. Do not know if they are still available, Call Ray.
Not likely on an ECU, I have never had to replace one on a SA/FB. One, someone putting a stereo in the car and crossed a couple of wires.
First go through check all basics. Got compression? fuel? spark? clear exhaust? GCFSE?
-Check all grounds and condition of battery cables and main wires. - 1
-Check water temp sensor and connector, I have seen a few where the harness and insulation looks good but the wires were broken. Test for continuity to ecu. -3
-Down load FSM from one of the download sites.
-other possibles
-bad vacumn leak - 2
-vent switch solenoid pack
-BAV
-TPS
-MAS
BTW - Nice find looks like everything is there and original, it will make it a lot easier to diagnosis.

Last edited by rx4ur7; 10-12-2010 at 06:18 PM.
rx4ur7 is offline   Reply With Quote