|
Welding on the plates is a lot easier said than done. Not that it's impossible, but it's not recommended.
I already checked everything with a spare rotor. It all checks out fine. I was just being over cautious. Side seal leading edge stays supported the entire time.
__________________
what I have:
1985 Gs:12a All motor Drag car - 1973 Rx2: Play car
What I had:
93 Touring: TRADED - 91 Coupe: TRADED - 90 GTU: RHD - 88 10AE: SOLD - 87 Base: SOLD - 86 Base: SOLD - 1985 GSLSE - 85 Gsl: SOLD - 80 Gs: TRADED - 1972 Rx2
|