Quote:
Originally Posted by proz07
interested on the meth setup for the FD. assuming some type of high speed valve controlled by the motec?
z
|
Yup, two ways I'm thinking about doing it. Either real injectors, or a pump controlled by a PWM output to vary the pressure and the flow.
There's going to be a few other failsafes in there as well all monitored and controlled by the MoTeC. Pressure comp maps, low level warnings, etc etc etc
Quote:
Originally Posted by vex
I could give you a simple (hand drawn) sketch of my plan and some details, but it might be a little much for me to make a 3D engineering sketch for it. I've just done a simple test design in Inventor--But what I really have planned will make you think it's pure genius!
|
Whatever you got, send it over or post it up.... I wanna see 
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
|