View Single Post
Old 12-28-2009, 07:52 PM   #33
thewird
Rotary Fan in Training
 
thewird's Avatar
 
Join Date: Mar 2008
Location: Toronto, Canada
Posts: 37
Rep Power: 0
thewird is on a distinguished road
Yah, I do but the RX-8 owner would have to order them for himself. I don't have his contact and Dave is on holidays so I can't let him know until he comes back. Hopefully they don't get sold by then. Worst case he has to wait for your next batch. So please let me know how I would proceed with my order. Thanks.

Also, forgot to mention these seals are your spotted seals that were in the oven too long ^_^. I'd like to say I love them.

Reason being when I was down at the gap, I was running a fuel pump backup wire which was too thin since my relay died. So the wire overheated and caused a fuel pressure drop causing me to go into a really bad lean condition. We had stopped at the bottom after a good while of going up and down the gap. When we left we all opened it up. I heard a strange sound which I realized after was AUDIBLE detonation, I looked down at my wideband while I was still WOT and saw 14.x AFR @ 16 pounds of boost. When I finally let off 2-3 seconds later, I immediately assumed engines gone. But to my surprise it sounded normal. I then tried it again to confirm and the same thing happened so I puttered it back to the cabin until I could fix the fuel issue. This was at around 5,000-10,000 km in the life of the engine. It has continued to run fine all season and now has 32,000 km. There is nothing wrong the engine, me and Dave are just curious on the internals. Anyway, just wanted to say I love your seals.

However, I always wonder if I had the same seals but in 2-piece if if they would have been so resilient. Thoughts?

thewird
__________________
thewird is offline   Reply With Quote