F/S dellorto carb and upper intake manifold cheap!
 

its used but ran when pulled off the car. the carb is mounted to the upper intake manifold wich was sold originally by racingbeat. it will bolt to the factory lower gsl-se intake or if you want to install it on a 12a simply purchase the racing beat lower and your done!
the dellorto is a 48mm carb and its got the linkage and accelerator cable bracket too :)
$325.00 shipped

WOW! I have been looking for one of these for a buddy of mine. I will hopefully get him on the phone tomorrow and close this deal.

im going to post some pics later today guys

When was it pulled? And what motor was it pulled off of?
I have a 12a "Large" Streetport I need a good carb for.

If it was recent (So I dont have to rebuild) and will work for my 12a I will take it.

sweet deal i used to have the same set up my se before i sold it. Awsome carb and intake.

im going to disassemble the carb, inspect it and do any nessisary cleaning, and replace gaskets if needed.
it should work good on a streetport 12a :)
and that primaflow you have ;)

sounds good, cant wait. Does it have a airfilter?

no air filter, sorry.took pics, brought the camera home, but forgot the cable.UGGHH! i will upload pics tomorrow night. carb does look good in and out though :)

No filter? So guess I will have to order one. Ok so I will offer
$300 shipped if its ready to be put to use and yes it is going on my streetport 12a, header and primaflow muffler.

pics
 

well, as you can see from the pics the carb looks new inside so, it should run great. the fuel jets are 230 and the idle jets are 75 . they too are super clean too

the carb is now back together boxed up and ready to ship

sold !close thread