Rotary Car Club

Rotary Car Club (https://rotarycarclub.com/index.php)
-   Show your rotary car build up. (https://rotarycarclub.com/forumdisplay.php?f=66)
-   -   GSL-SE 13B PP build (https://rotarycarclub.com/showthread.php?t=17822)

angelpr06 11-11-2013 10:39 AM

GSL-SE 13B PP build
 
1 Attachment(s)
Just started the build, have the PP motor on the stand and hopefully by next spring will have it running, still need to buy the carb intake and fuel pump, I think I will go with the Racing Beat 51mm Weber and Mallory pump.

Does anybody have a wiring diagram of the ECU harness? I want to know if I can pull the whole thing out or it need to stay for other reasons.

Whizbang 11-11-2013 11:04 AM

how did you do the peripheral port? Racing Beat housings or home made?

angelpr06 11-18-2013 06:42 PM

Made by Mike performance in Puerto Rico.

RICE RACING 11-18-2013 07:01 PM

I had pretty much exactly that set up in 1992.

Here is some pics

http://imageshack.com/a/img812/1284/j8ct.jpg

http://imageshack.com/a/img707/3570/c2mv.jpg

This is the 13B PP motor in bottom left corner (this was run in the Silver first gen 1992 to 1997), after that I woke up and went turbo and different 1st gen RX7, that was my favorite of all time, very light stupid fast and at the time no cuuuuuunt had anything like it!

http://imageshack.com/a/img109/2719/ulwu.jpg


13B Peripheral Port
51 IDA (full proper carb)
Was daily driven for 5 years? or so... Did over 50,000km with that motor, in that time used 2 sets of RB carbon Apex Seals (have pic of them on my web site) they got taper chewed on outer tips after long street use.

Hated the engine and loved it at same time, but mostly hate, too slow, shocking fuel use, loud! :smash:


All times are GMT -5. The time now is 01:19 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com