Rotary Car Club - New From Tennessee

Rotary Car Club (https://rotarycarclub.com/index.php)

- Introduce yourself!! (https://rotarycarclub.com/forumdisplay.php?f=64)

- - New From Tennessee (https://rotarycarclub.com/showthread.php?t=16167)

New From Tennessee

Hello everyone. My name is Matt. I drive a 1990 RX7 GTU. Its a project/daily at the moment. Im planning a full T2 drivetrain swap with powered by max coilovers by the end of winter. This is my second RX7. My first one was stolen (10 AE model) and after a few years I finally found another one for a good price that just needed a bit of work. My current S5 has a rebuilt motor and trans with a stage 2 clutch and a racing beat cat back exhaust with a test pipe running from the header to the cat back. Ive only done small mods so far such as a miata short shifter and an hks intake. Here are a few pictures.She isnt pretty at the moment but when I get the wide rears and paint on it should look alot better.

http://sphotos-b.xx.fbcdn.net/hphoto...94890543_n.jpg

http://sphotos-a.xx.fbcdn.net/hphoto..._6989808_n.jpg

http://sphotos-a.xx.fbcdn.net/hphoto...37485147_n.jpg

http://sphotos-b.xx.fbcdn.net/hphoto...64603521_n.jpg

http://sphotos-b.xx.fbcdn.net/hphoto...40027018_n.jpg

http://sphotos-b.xx.fbcdn.net/hphoto...93937797_n.jpg

http://sphotos-b.xx.fbcdn.net/hphoto...61818202_n.jpg

Welcome to the darkside.......... Faggot.

Hey Vinnie I assumed you would post here. I've got an exciting meeting with a machine shop on Monday that involves 4 housings.

Do tell.... Machine shops round here I've dropped off to clean first words out of their mouths were.... WTF IZ THAT THUR?!?!? I just chuckle.

Im going on monday to check on the price to build a 4 rotor eccentric. Apparently he builds custom cranks on the cheap so Im going to see pricing and then potentially do something really stupid with alot of money

Wowzers.... LMK the details on it..... Would love to have one.

Ill let you know his pricing as soon as I find out. I may need to hit you up for a rebuild soon. My OMP just stopped working and I feel like Ive lost power so Im going for a comp test this week as well

If I had to guess, I'd say close to $5k, but that all depends on the setup, and since it's a 1 off billet, it could be as much as $10k. Most CAD quotes I've gotten alone for manufacturing / engineering are in the $3000~$5000 range, and that's just for a cast rotor. I had them spec out my 3rotor shaft and it's about the same general cost, but cheaper to actually cast at around $200 a slug.

GL, I'll be curious to see what they quote you...