FS: FD Engines - Stock, Streetported, & Bridgeported
 

1) Stock "FD" RX7 13B-REW Engine- $3000.00 plus shipping
http://i153.photobucket.com/albums/s...FDEngine_2.jpg
http://i153.photobucket.com/albums/s...FDEngine_1.jpg
http://i153.photobucket.com/albums/s...kFDEngine3.jpg

2) Streetported "FD" RX7 13B-REW Engine= $4000.00 with Racung Beat aluminum flywheel, (as pictured)
or $3500.00 with stock flywheel

http://i153.photobucket.com/albums/s...ortEngineA.jpg
http://i153.photobucket.com/albums/s...ortEngineC.jpg

3) Bridgeported "FD" RX7 13B-REW- $4800.00 Secondary ports only have large Bridgeporting, primary ports are Streetported, Rotor Housings are match ported for the secondary ports intake bridgeporting and exhaust ports are also ported. Includes stock flywheel- Good used Racing Beat aluminum flywheel also available with this engine for additional cost $400.00

http://i153.photobucket.com/albums/s...tFDEngine1.jpg
http://i153.photobucket.com/albums/s...tFDEngine2.jpg




These engines were built to our our competition proven specifications and include all new seals, springs, 0-rings, bearings & gaskets, also include upgraded apex seals, combustion & water seals

Stock Engines are warranted for 1-yr.
*Engine Core return required on each engine- $900.00 core charge if no core returned
*Warranty does not cover damage caused by turbo overboost or lean operation under boost.

For more information- http://rotorsportsracing.com/perform...ng/engines.htm
(please note- our website has not been updated in 6 yrs, so pricing listed on site is inaccurate)

Please contact us with any questions,

Bryan Smith
Rotorsports Racing
465 Russell Farm Rd.
Kannapolis, NC 28081
(704) 933-6222

email- info@rotorsportsracing.com

sale pending on stock ported engine

Nice looking motors...

Hi Bryan,
are these motors equivalent to your sites' "Stage 1" build?

To answer your question....Yes & No

Our website hasn't been updated since '05 (but soon to be revamped), so both specs and pricing have changed. They are prepped to our latest Stage 1 specs but with improvements that are not listed on website.

All Stage 1 engines now receive new upgraded and cryogenic treated apex seals and springs in addition to all the other new seals, springs, bearings, 0-rings, oil seals gaskets, assembly also includes a new Mazdaspeed metal front cover gasket (we've never had one of these fail or leak!)

E-shaft is checked for "run-out" then polished and thermal pellet installed, Side Housings are checked for wear and micro-lapped and ultra-sonic cleaned. Oil pressure regulator is pressure verified & oil pump is also clearanced & wear checked and tested.

**The "Stock" ported Engine and the "Streetported" Engine have both been sold as of 11/01/'11