Hoe Shit! Fuck that! Did you add extra grounds and use lots of dielectric grease?

No extra grounds, but I had the greased them up good. I'm going to depin all the clips and scrub the hell out of all the tabs then crimp the female side so the pin will barely fit in. Also going to check the crimps on all the pins. Will probably just flow some solder into the crimped clips for good measure.

If this doesn't work, then I'm just going to drop the damn electric steering for a different rack. Probably use a Mark III MR2 electric motor.

Don't use the solder, it will actually hinder with more resistance.

Why the fuck did I even look in this thread? I knew it would just make me sad :( Not going to make it this year, currently bleeding out on a rebuild on the 8 that won't be done in time, and even if the car was done wouldn't have the cash to make it happen. next year for sure the 8 will make a reappearance!

Just re-crimp if it's loose?

Yup. The crimps aren't what gets loose, it's the connector itself where the contact is made

Final count for online registration.. 197.

I'd say that we'll have about 250 people this year. It started out a little slow, but lots of people registered in the last month or so.

See everyone tomorrow!

Nope but have FUN EVERBODY! :grouphug:

Just finished detailing the FC and am ready to roll at the crack of dawn tomorrow. :driving:

See you all at the lodge! :cheers2: :party:

Yeah this guy has my Motor...:o10:

And if I ever get off my lazy arse, it will be built up, in my FC, broken in and tuned before next years DGRR :cheers2: