Got my coils in and finished the coil bracket that was started a LONG time ago.

https://lh3.googleusercontent.com/-C...215_194928.jpg

Didn't have the right length spacers, but you get the idea.

https://lh3.googleusercontent.com/-k...215_195714.jpg

https://lh3.googleusercontent.com/-8...215_195727.jpg

https://lh3.googleusercontent.com/-J...215_195908.jpg

Nice bracket! I made one for the stock location too but they sit closer to the edge of the engine and yours is finished better lol.

Thanks, finally getting a belt sander has dramatically improved the finish quality :rofl: Are you using the IGN-1A also? They're not small coils. It was really damn tight under there between the UIM and the fuel lines.

Good lord man, didn't I cut that out almost a year ago? :smilielol5:

Just as an afterthought for the REW mani, I integrated an UIM support for my RE

Maybe... :suspect:

I didn't have the coils to test fit everything, so I didn't weld it up. It wasn't high on the priority list. You tied the UIM into your coil bracket?

Yeah.... not high on the priority list for sure.

Yes, Yes I did tie it into the UIM

I didn't sand or coat mine or anything lol. It looks pretty rough. Yeah I'm using those coils too. I had to remove the coolant outlet nipple on the bottom of the throttle body to get it to almost sit on top of the coils (it's that tight), but I wanted short plug wires and that's what I got lol. I just need to figure out a way to duct cool air to them or wrap them in reflective barrier. I'll see if I can find a pic so you can see how they sit. Although it doesn't really matter since you did yours already lol and I'm not trying to hijack.

EDIT: Here we go.
http://i44.photobucket.com/albums/f9...psfogvgb6q.jpg
http://i44.photobucket.com/albums/f9...psre1eydt3.jpg

Looks good to me :icon_tup:
I like how far over you got them. Would have made my fuel line routing easier. Mine are quite close to the UIM as they sit.

https://lh3.googleusercontent.com/-u...215_200029.jpg

Eric, don't wrap them in anything, you'll contain more heat than you reflect

That was another concern I had, not having enough room for the wiring harness or whatever else would be a headache. But with yours it looks like you'll still have enough room for everything and it doesn't look like you had to modify too much to get it that way. It looks good!

I didn't realize how big these coils were and how much of a PITA it would be to make them fit there lol.

OK I'll just see if I can find a way to run cool air to them then. Thanks!

Fabbed up a 4" downpipe. Still need to add O2 bungs.

https://lh3.googleusercontent.com/-L...228_194846.jpg

https://lh3.googleusercontent.com/-I...228_194917.jpg

High Precision Tato Cannon?:drool5:

Indeed!

NIOCE! Pics installed!

Sure.

https://lh3.googleusercontent.com/-T...230_130433.jpg

https://lh3.googleusercontent.com/-M...230_130451.jpg

https://lh3.googleusercontent.com/-v...230_130520.jpg