My 20B breakdown...

[Herblenny]

Well, Finally we've decided to break down the 20B.. Here are few pics..

http://rotarycarclub.com/rotary_forum/attachment.php?attachmentid=4209&stc=1&d=1234191046

http://rotarycarclub.com/rotary_forum/attachment.php?attachmentid=4210&stc=1&d=1234191063

http://rotarycarclub.com/rotary_forum/attachment.php?attachmentid=4211&stc=1&d=1234191071

http://rotarycarclub.com/rotary_forum/attachment.php?attachmentid=4212&stc=1&d=1234191076

http://rotarycarclub.com/rotary_forum/attachment.php?attachmentid=4213&stc=1&d=1234191081

[Kwerks]

Come on I know you must have more photos than that =)

[War Eagle]

Phil, what's the scoop on the engine? One you have had around and are just now getting to rebuilding. Where did it come from and what are your plans?

[Herblenny]

David,

I have two 20Bs.

The one pictured is a number series that I'm planning to go NA with with S5 high compression rotors (like Gordon's) and 13b housings. The housing and everything looks really good (very low miles) except one rotor and housing...

The other one is D series 20B which will be built and cranked on a table by end of this month. That one will be a turbo'd 3 rotor. It will be ported (bit bigger than stock) with exhaust sleeves taken out for better flow. I'll have videos of the engine cranked on a table when its ready :)

[Jeff20B]

Herblenny, about the exhaust sleeves, were you leaving them out, or will you throw in some T2 sleeves?

[Herblenny]

I believe we are going to put 13B REW sleeves.

[Jeff20B]

Ok, thanks. Looks like I'll need to pick up one more T2 sleeve for mine.

[vincentrx7]

Phil, What are you going to put it in?...your RX8??????? That would be cool!

[Herblenny]

Phil, What are you going to put it in?...your RX8??????? That would be cool!

I'm going to put them in the FD... then something else :)

[need RX7]

I'm going to put them in the FD... then something else :)
My FC? :)
:rofl:

[gmonsen]

Phil... Will it be ready for DGRR?

[Herblenny]

Gordon, Most likely its not going to be ready :(

If the engine is ready, I might bring it up there for people to see. But not in the car.. I'm still quite a bit away from finishing the car.. If I could just get the car running with 13B-RE, I'll be happy.

[gmonsen]

Gottcha...

Gordon

[Rotary13B1]

*bowing down* to TWO 20B motors...Hurry up and get it running Phil.

[Herblenny]

*bowing down* to TWO 20B motors...Hurry up and get it running Phil.

I'm working on it:) I think the FI motor will be done in next 2 weeks.. I had a last minute change of things and we are now designing few things by No Limit Industries. Todd, the owner is going to build some cool stuff for this motor (pressure to Todd :)).

[albertomg]

What was the condition of the internals when you broke them down? Did they look bad in anyway or usable in a non-stressed normally aspirated setup?

Did you buy them from Japan2LA?

Thanks.